Honda HondaJet HA-420 Pilots Operating Manual page 387

HA-420
POM
The areas listed below require special attention during the ground de-
icing process.
CAUTION
Horizontal Tail
Remove all accumulations from the upper surface of the stabilizer and
elevator. The gap between the elevators / elevator horn and horizontal
stabilizer should be free of snow/ice accumulation. Ensure that elevator
attach/hinge points and elevator horn are completely de-iced.
NOTE
Vertical Stabilizer/Rudder
The leading edge of the vertical stabilizer as well as the side panels and
rudder should be cleaned of any snow/ice accumulation. The gap
between the rudder and vertical stabilizer should be free of snow/ice
accumulation. Ensure that rudder and rudder trim tab attach/hinge points
are completely de-iced.
NOTE
NOTE
October 30, 2016
Honda Aircraft Company
If snow or ice has accumulated on the horizontal tail,
the tail must be de-iced first
Minimize spray into the elevator control surface cavities.
Minimize spray into the NACA inlets on the leading
edge root of the vertical stabilizer.
Minimize spray into the rudder control surface cavities.
HJ1-29000-005-001
FOR TRAINING PURPOSES ONLY
SERVICE, HANDLING,
AND MAINTENANCE
4-39