Table of Contents
Advertisement
Network Configuration
4.5.1
TCP/IP
Use the setup menu below to adjust the camera's TCP/IP settings.
Chose to use IPv4 or IPv6 tabs to setup the camera's IP settings. Contact your network administrator for more
information.
•
Obtain an IP address automatically: when selected, the camera will obtain its IP address and network
settings based on the information from the router.
•
Use the following IP address: Enter the camera's IP address manually. If this option is selected, enter the
following information:
o
IP Address: enter the camera's IP address in the format of xxx.xxx.xxx.
o
Test: use this option to test the camera IP address is correct and available.
o
Subnet Mask: enter the network's subnet mask in the format of xxx.xxx.xxx.
o
Gateway: enter the router's gateway address in the format of xxx.xxx.xxx.
o
Preferred DNS Server: enter the DNS server for the camera.
o
Alternate DNR Server: if needed, enter a secondary DNR server's address.
Use PPPoE-Click the "PPPoE Config" tab to enable PPPoE. Enter the username and password. Contact your
network administrator for more information.
If PPPoE is used to connect to the internet, the camera will get a dynamic WAN IP address. This IP address will
change frequently.
-30-
Advertisement
Table of Contents
