Network Configuration; Tcp/Ip - Digital Watchdog MEGApix DWC-MV95Wi28TW Owner's Manual

6. Make sure cameras can view objects for at least 2 seconds in the detected area
for accurate detection.
7. Adequate light and clear scenery are crucial to perimeter intrusion detection.

5.5 Network Configuration

5.5.1 TCP/IP

Go to Config > Network > TCP/IP interface as shown below. There are two ways
to setup the network connection.
Use IP address (take IPv4 for example)-There are two options for IP setup:
obtain an IP address automatically by DHCP and use the following IP address.
Please choose one of the options as needed.
Test: Test the effectiveness of the IP address by clicking this button.
Use PPPoE-Click the "PPPoE Config" tab to go to the interface as shown below.
Enable PPPoE and then enter the username and password from your ISP.
Either method of network connection can be used. If PPPoE is used to connect
the internet, the camera will get a dynamic WAN IP address. This IP address will
change frequently. To be notified, the IP change notification function can be
used.
30