Electrical Connections - Riello BAG3 MIX FAMILY COND Instructions For The Installer And For Technical Assistance

2.6 Electric connections
To form the electrical connections for the
COND
, access must be obtained to the
COND
and the boiler card.
To gain access to the BAG
- Remove the front cover panel from the BAG
COND.
In the appliance you find connected:
- white cable for main supply
- black cable with 5 poles collector
- black bipolar cable with probs
In the envelopes you find:
- flat cable
- faston jumper
- probe wiring and thermostats
- PCB supply cable - 4 poles
If you decide to use cables other than those supplied, ca-
bles with a 0,50 mm section must be used. The length of
2
these connections must not exceed 15 metres.
CONNECTING THE ELECTRONIC SYSTEM CONTROL BOARD (sup-
plied) TO THE BOILER'S ELECTRONIC BOARD
To form the connection, proceed as follows:
1. Remove the boiler's cover, open the back cover on the
control panel, as shown in the manual for the boiler.
2. Insert the BE08 board supplied (C) into its seating inside
the control panel, as shown in figure 2.
3. Connect the flat cable to the electronic system control
board and the electronic boiler control board (see photo
1 and the wiring diagram).
4. To provide power to the electronic system
control board, connect the cable's four-pole connector
(supplied), as shown in photo 2
Connect the prods to the mains power supply as shown
in fig. 3
Blue wire - neutral
Brown wire - phase
(see the wiring diagram)
photo 1
inside boiler
photo 2
inside boiler
BAG MIX FAMILY
3
BAG MIX FAMILY
3
MIX FAMILY COND:
3
MIX FAMILY
3
outside boiler
outside boiler
Boilers from inside
Fig. 1
Boilers from outside
C C
Fig. 2
30
C
outside boiler
outside boiler