Configuration Setting; Multipoint Pairing - Sena Expand Boom User Manual

Outdoor bluetooth communication system

Hide thumbs Also See for Expand Boom:

Table of Contents

9 CONFIGURATION SETTING

You can set the configuration of the Sena Expand Boom by the voice

menu instructions as below.

1. To enter the voice configuration menu, press and hold the Center

Button for 12 seconds until the LED shows solid blue and you

hear high tone double beeps. You will also hear a voice prompt,

"Configuration menu".

2. Tap the (+) Button or (-) Button to navigate between the menus.

You will hear voice prompts for each menu item as below.

3. You can enable / disable a feature or execute a command by

tapping the Center Button.

4. If you want to exit configuration immediately, press and hold the

(+) Button or (-) Button until you hear a voice prompt, "Exit

configuration", then tap the Center Button.

The voice prompt for each menu item is as follows:

(2) Phone selective pairing

(3) Media selective pairing

(4) Speed dial

(5) Voice prompt

9.1 Multipoint Pairing

Voice Prompt

Factory Default

To go into multipoint pairing mode, tap the (+) Button or the (-) Button

until you hear a voice prompt, "Multipoint pairing". Please refer to

section 3.2 for details on multipoint pairing.

Expand Boom

(6) Noise control

(7) Delete all pairings

(8) Universal Intercom Pairing

(9) Factory reset

(10) Exit configuration

"Multipoint pairing"

N/A

Table of Contents