¸
¹
¶
16
Inserting and changing the battery
Unscrew the display section
Slide back the display section
¿
becomes fully accessible.
Insert the 9 V PP3 alkaline battery (IEC 6 LR 61). Please observe
correct polarity when inserting the battery.
Push the battery compartment into the radiomicrophone's body.
Screw the display section tight.
To change the battery, press out the battery from below (press
in the direction of the arrow).
Switching the transmitter on/off
Turn the protective cap
so that the
ON/OFF
Press the
ON/OFF
button
¸
LED
lights up.
To switch the transmitter off, press the
"OFF" appears on the display. You can then release the button.
¸
The red LED
goes off.
NB: The on/off switch is a touch switch and only light pressure is
required.
Muting the transmitter
Use the
MUTE
switch to noiselessly mute the transmitter's audio
signal (this switch does not switch off the transmitter).
´
by turning it counter-clockwise.
´
until the battery compartment
¶
at the bottom of the radiomicrophone
button becomes accessible.
¹
to switch the transmitter on. The red
ON/OFF
button until