TP-Link TL-WA5210G Installation Manual page 22

T1. How do I restore my AP's configuration to its factory default
settings?
With the AP powered on, press and
hold the RESET button for about 8
seconds before releasing it.
Hold it in for about 8 seconds
You will need to assign your computer a Static IP address within
Note
the same range as the AP's IP address. See the Appendix 2:
Troubleshooting - T3 if you need assistance.
T2. What can I do if I forget my password?
1) Restore the AP's configuration to its factory default settings. If you
don't know how to do that, please refer to previous section T1;
2) Use the default user name and password: admin, admin;
3) Try to reconfigure your AP by following the instructions of this QIG.
T3. What can I do if I cannot access the web-based configuration
page?
You should first configure your computer's IP Address.
Please follow the steps below to finish your PC configuration.
¾ For Windows 7 OS
Go to Start > Settings > Control
Panel, and then you will see the
following page.
Click View network
status and tasks
Appendix 2:
Troubleshooting
20