TP-Link TL-WA5210G Installation Manual page 16

2
Connecting the Device
Note
Please use only wired network connections to configure the AP.
Locate a suitable mounting site for your CPE. For choosing the
best location, select an elevated location where trees, buildings
and large steel structures will not obstruct the antenna signals and
which offers maximum line-of-sight propagation with the users.
Adjust the direction of your CPE for the best signal. Place the
straps through the slots on the back of the CPE and then around
the pole. Tighten the straps.
Connect one end of an Ethernet cable to the POE port of the
provided Power Injector and the other end of the Ethernet cable to
the LAN port of the CPE.
Then, connect the LAN port
of the Power Injector to a PC
using another
cable. Finally,
provided power adapter into
the DC jack on the Power
Injector, and the other end to
a standard electrical wall
socket.
Ethernet
plug the
14