Mitsubishi Electric FR-V500 Series Instruction Manual page 49

Control mode switchover timing
Pr.800
setting
Terminal Speed
name control
Multi-function
DA1
monitor 1
Analog
output
Multi-function
DA2
monitor 2
*: Assumes that the Pr. 868 value is the factory setting.
Related parameters
• DI1 to DI4, STR terminal function selection ⇒ Pr. 180 to Pr. 183, Pr. 187 (input terminal function selection). (Refer to page 65.)
• DO1 to DO3, ABC terminal function selection ⇒ Pr. 190 to Pr. 192, Pr. 195 (output terminal function selection). (Refer to page 65.)
• Terminal 1 function selection ⇒ Pr. 868 "terminal 1 function assignment" (
• Terminal 1, 2, 3 bias/gain adjustment ⇒ Pr. 902 to Pr. 905, Pr. 917, Pr. 918 (bias/gain adjustment) (Refer to page 51.)
• DA1, DA2 terminal function selection ⇒ Pr. 54, Pr. 158 (DA1, DA2 function selection) (Refer to page 60 (DA1) and page 64 (DA2).)
• DA1, DA2 terminal calibration ⇒ Pr. 900, Pr. 901 (DA1, DA2 terminal calibration) (Refer to page 26.)
• MC signal terminal assignment ⇒ Set "26" to any of DI1 to DI4 and STR using any of Pr. 180 to Pr. 183 and Pr. 187 (input terminal
function selection). (Refer to page 65.)
• Control method selection ⇒ Pr. 800 (Refer to page 57.)
0 1
MC signal
Torque ON
control
Speed
control
←
←
Description
2 3
OFF Position
control
Torque Speed
control control
← ←
← ←
Refer to the Instruction Manual (detailed).)
46
4
MC signal MC signal
ON OFF ON
Position Position
control control
←
←
5
OFF
Torque
control
←
←