LaserLiner SuperCross-Laser 2GP Manual page 11

2
Horizontal and vertical levelling
Release the transport restraint, set slide switch
to „ON". Laser-emitting window, plumb
laser. The laser lines can be switched with the
selector button.
! The transport restraint must be released for horizontal and vertical levelling. The laser lines flash and the LED
lights red as soon as the device is outside the automatic levelling range of 4°. Position the device such that it
is within the levelling range. The LED switches back to green and the laser lines stop flashing (steady light).
3
Slope mode
Do not release the transport restraint, set slide switch to „OFF". Select and switch on the laser
with the selection button. Sloping planes can now be measured. This mode cannot be used
to perform horizontal or vertical levelling as the laser lines are no longer aligned automatically.
The LED lights constantly red.
4
Hand receiver mode
Optional: Working with the laser receiver GRX
Use an GRX laser receiver (optional) to carry out levelling at great distances or when
the laser lines are no longer visible. To work with a laser receiver, switch the linelaser
into hand receiver mode with the Hand receiver mode button. The laser lines will
now pulsate with high frequency, making the laser lines darker. The laser receiver
can detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
Preparing the calibration check
It is possible for you to check the calibration of the laser. To do this, position the device midway between 2 walls,
which must be at least 5 m apart. Switch the device on (Laser cross ON).
The best calibration results are achieved if the device is mounted on a tripod.
SuperCross-Laser 2GP
LASER LASER LASER LASER
EN
11