Technical Data; Environment Concerns - Electrolux ESL 45015 User Manual

32 electrolux
Problem
The dishes are wet.
The dishes are wet and dull.
How to activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and
C until the indicator lights for function but-
tons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function but-
tons A and C go off.

TECHNICAL DATA

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of
the appliance door shows the electrical
connection data.
If the hot water comes from alternative
sources of energy, (e.g. solar panels,

ENVIRONMENT CONCERNS

The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will
help prevent potential negative
Possible cause
The detergent can be the cause. Use a different brand of deter-
You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on (this
function automatically deacti-
vates the rinse aid dispenser).
6. Press function button B again.
7. Switch off the appliance to keep the op-
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
consequences for the environment and
human health, which could otherwise be
caused by inappropriate waste handling of
this product. For more detailed information
about recycling of this product, please
contact your local council, your household
waste disposal service or the shop where
you purchased the product.
Possible solution
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispense.
– The indicator light for function button
B continues to flash.
– The end-of-programme indicator light
comes on.
eration.
To deactivate the rinse aid dispenser,
do the same procedure until the end-of-
programme indicator light goes off.
photovoltaic panels and aeolian), use a
hot water supply to decrease energy
consumption.
446 mm
818 - 898 mm
550 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
9