Use Of The Appliance; Setting The Water Softener - Electrolux ESL 45015 User Manual

22 electrolux
Setting mode
The appliance must be in setting mode
for these operations:
• To select and start a washing pro-
gramme and/or a delay start.
• To adjust electronically the level of the wa-
ter softener.
• To activate/deactivate the multitab func-
tion.
• To activate/deactivate the rinse aid dis-
penser.
• To deactivate/activate the audible signals.
Press the on/off button. The appliance
is in setting mode when:
– All the programme indicator lights come
on.
Press the on/off button. The appliance
is not in setting mode when:
– Only one programme indicator light
comes on.
– It is necessary to cancel the pro-
gramme or the delay start to go back
to the setting mode. Refer to 'Select
and start a washing programme'.
Audible signals
The audible signals indicate:
• The end of the washing programme.

USE OF THE APPLIANCE

1. Be sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water soft-
ener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the appli-
ance.
5. Set the correct washing programme for
the type of load and soil.

SETTING THE WATER SOFTENER

The water softener removes minerals and
salts from the water supply. These minerals
and salts can cause damage to the appli-
ance.
• The electronic adjustment of the level of
the water softener
• The appliance has a malfunction.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and
C until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons B and C.
5. Press the function button C.
– The indicator lights for function but-
tons A and B go off.
– The indicator light for function button
C flashes.
– The end-of-programme indicator light
comes on.
• The audible signals are active.
6. Press the function button C again.
– The end-of-programme indicator light
goes off.
• The audible signals are deactivated.
7. Switch off the appliance to keep the op-
eration.
Do the above procedure to activate
again the audible signals.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
If you use the combi detergent tablets
('3 in 1', '4 in 1', '5 in 1'), use the multi-
tab function (refer to 'Multitab function').
Adjust the level of the water softener if this
does not agree with the water hardness in
your area.
Contact your local water authority to know
the water hardness in your area.