Initialized Wb/Gamma Adj. Data In B Board - Sony KJ-32W7 C Series Service Manual

Service Adjustment
Save Changing Data by Service Mode 2
1. In "Digital" service mode ( "002 MODEL" category)
001 SEG Select segment information
002 DEST Select destination information
003 MODELNAME Select Model Name
004 SERIAL Can be set Only Once for the new board
005 SHIP_CONFIRM ...Can set correct Product Code
006 VAR_TYPE Select variable information
a. Change data for each model. (Refer to Part B)
b. Press "Mute", "0" on remote sequentially. Red "WRITE" is
shown. This indicates writing is in process.
c. After a while, red "WRITE" disappears. Green
displayed for a while, which means writing process is done.
d. For the items SEG, DEST, MODELNAME and VAR_TYPE
after changing each item, service save ("mute"+"0") is
required. For the item SERIAL, after inputting the serial
number, press key "12" or "Enter" to save the data.
– Please save the items according to the sequence "SEG ->
DEST -> MODELNAME ->VAR_TYPE
– When Saving the item "SEG", sometimes instead of
"Writing", the word "Pending" will appear. In this case, skip
"SEG", saving " DEST", "MODELNAME" and "VAR_TYPE"
is OK
a a
a
b
b
Remote Commander
Only when B* board is replaced.
DIGITAL SERVICE
002 MODEL
001 SEG HS_BASE
Write
VIDEO:STANDARD AUDIO:STANDARD
PSAVE:STANDARD
MAIN: SUB:
TUNER/----/---- ----/----/NTSCU
----X----/----- ----X----/-----
-----/--- -----/---
DIGITAL Service menu

4-5. Initialized WB/Gamma Adj. Data in B board.

After panel replacement, update the software to
PKG2112 and perform this function.
.
1.in "VPC" service mode
a.Select "002 DATA_INIT" category by pressing "2 / 5" on remote.
b.Change data from "0" to "1" by pressing "3 / 6" on remote.
c.Wait until data is changed from 1 to 3.
d.When data is changed from 1 to 3, restoring process is finished.
e.In case data is changed from 1 to 2, , restoring process is failure.
*(Please confirm B board (BAX-L) and repair for reference,
Done will be
b
a
Remote Commander
Failure restore process
VPC SERVICE
002 DATA_INIT
000 WB_INIT
DO NOT POWER OFF
DO NOT TOUCH ANY KEY NOW
VPC SERVICE
002 DATA_INIT
000 WB_INIT
DATA TRANSFER SUCCESS
VPC SERVICE
002 DATA_INIT
000 WB_INIT
DATA TRANSFER NG
XML models
1
Restore process
3
End restore process
2
177