Table of Contents
Advertisement
Service Adjustment
4-6. VCOM Adjustment (NFR-AUO/SDC/FXC Panel)
4-6-1. STEP1
1. in "Digital" service mode
a.
Select "003 DIG_SRV_MODE" category by pressing "2 / 5" on
remote.
b.
Press "0" to go to "TEST PATTERN" Mode.
c.
Press "Enter" or "12" to go into Video TEST PATTERN.
d.
Press "7" or "8" to select the test pattern
e.
Press "Enter" or "12" twice to show the VCOM TEST PATTERN.
DIGITAL (DIG_SRV_MODE)
TEST PATTERN
--> 1 Video
*1 White
2 Ramp
3 R Raster
4 G Raster
5 B Raster
6 Color Bar
7 VCOM Pattern1
8 VCOM Pattern2
9 Off
SERVICE
4-6-2. STEP2
2.in "VPC" service mode
a.
Select "002 VCOM" category by pressing
"2 / 5" on remote.
b.
Select "000 ENABLE" item by pressing "1
/ 4" on remote.
c.
Change ENABLE from "0" to "1" by
pressing "3" to enable VCOM adjustment.
4-6-3. STEP3
3.
in "VPC" service mode
a.
Select "002 VCOM" category by
pressing "2 / 5" on remote.
b.
Select "001 ADJUST" item by
pressing "1 / 4" on remote.
c.
Change data by pressing "3 / 6" on
remote.
4-6-4. STEP4
4.
DIGITAL
SERVICE
007 VCOM
000 SRV_OSD_EN
1
VIDEO:STANDARD AUDIO:STANDARD
PSAVE:STANDARD
MAIN:
SUB:
TUNER/----/---- ----/----/NTSCU
----X----/----- ----X----/-----
-----/---
-----/---
VPC
SERVICE
002
VCOM
000
ENABLE
VPC
SERVICE
002
VCOM
001
ADJUST
in "Digital" service mode
a.
Select "007 VCOM" category by
pressing "2 / 5" on remote.
b.
Change data from "1" to "0" by
pressing "3 or 6 " on remote.
c.
Confirm the final result of the
VCOM adjustment .
d.
If OK, Finish the VCOM
adjustment. If NG, pressing "3 or
6" to show the OSD again and
go back to VCOM adjustment
Step 3.
0
64
178
Advertisement
Table of Contents
