Bosch Rexroth PS5000 Commissioning And Operating Instructions page 46

4−16 Bosch Rexroth AG
Operation
Electric Drives
and Controls
8. If the superordinate code is to be changed, enter this code now and
then press
Starting at this time, access to the "Change code" mode is possible
only with the superordinate code that was just entered.
9. Press the
The next code screen opens.
1st line: Change code
2nd line:<What is protected> (e.g. main menu entry RUN)
3rd line: Access
4th line: Change .0
If no code is required, a value of "0" must be entered.
D Codes in line "Access":
Access to the submenu is protected by a code. All data can only be
displayed even after the correct code has been entered.
D Codes in line "Change":
Data in the submenu can be changed only after entering the valid
code.
To define codes here, continue with 10., otherwise with 12.
10. Use key or
ter the code.
11. Use key to activate the displayed code.
– or –
key to reset the entered value to the default value.
To enter additional codes, continue with 10., otherwise with 12.
12. Press the
To change codes, continue with 10., otherwise with 12.
If all the screens for assigning codes have been opened, the BT
.
6.190 displays the device type and information regarding the cur-
rent firmware version if key
key to return to the uppermost menu level.
.
key.
.0
to select the desired line (Access, Change) and en-
key to call the next code assignment screen.
is pressed. In this case, press the
BT 6.190 1070087068 / 01