Advertisement
RC4000 Antenna Controller
Miscellaneous Command (continued)
*the 47h key code can be used to initiate a RC4000 mode group change which normally requires the
Mode key to be held down for five seconds continuously.
The reply to the miscellaneous command will be the same as the reply to the status poll query except the
command code will be '36h'.
Appendix REM
'X' = 'A'
This sub-command is used to initiate an automatic search
pattern via the RC4000. The sub-command parameter 'Y' must
be either an 'E' to initiate an expanding spiral or 'F' to initiate a
"flat" spiral pattern. NOTE: Be sure the RC4000 is configured
correctly for automatic searching.
'X' = 'K'
The Keypad Input sub-command sends a keypad value to the
RC4000. The RC4000 will react to the keypad value as if the
corresponding key on the RC4000 front panel was pushed. The
required values for the 'Y' subcommand are:
'Y'
30-39h
41-47h
CODE
30h
31h
32h
33h
34h
35h
36h
37h
38h
39h
3A-3Fh
41h
42h
43h
44h
45h
46h
47h
REM-21
key codes as defined in the following table
KEY
0/Speed
1/Pol CCW
2/N/EL UP
3/Pol CW
4/E/AZ CCW
5
6/W/AZ CW
7/H
8/S/EL DN
9/V
-- unused –
Stop/Decimal
+/-/BKSP
Mode
Scroll Up/Yes
Scroll Dn/No
Enter
Mode Group Change*
Remote Control Option
Advertisement
