Bennett Read Power Up Pet Advanced User Manual page 12

EMPTY DIRT CONTAINER
The dirt container should to be emptied before the dirt reaches the "Full" line on the container.
1. Unplug the vacuum
from electrical outlet
2. Lift the Dirt Container
(10) from the vacuum
cleaner by pressing
the Dirt Container
Release Button (5)
and pulling the Dirt
Container outwards
3. Hold the Dirt
Container over a dust
bin and press the Dirt
Container Release
Button to release the
bottom lid
!
NOTE:
CLEANING THE PRE-MOTOR
AND POST-MOTOR FILTERS
1. Unplug the vacuum
from electrical outlet
2. Pre-motor filter (19):
Remove the Dirt
Container from the
vacuum. Turn the
Lid anticlockwise to
unlock it. Remove the
foam filter and hand-
wash it in cold water
3. Post-motor filter (20):
Remove the Dirt
Container from the
vacuum. The Post-
motor filter is located
in the main body of
the machine under
!
NOTE:
!
WARNING:
4. Shake the Dirt
Container or gently
tap its side to ensure
all dirt and dust is
released into the
dust bin
5. Close the bottom lid
and return the Dirt
Container to the
Vacuum cleaner by
inserting the bottom
part first and then
gently clip the top
back in place
Emptying the dirt container after every use will help prevent over-filling
and ensure that the vacuum is ready to go the next time you clean.
the Dirt Container.
Turn the Post-motor
Filter Lid anticlockwise
to remove it (Fig.
3.1). Then twist the
Post-motor Filter
anticlockwise to
unlock it (Fig. 3.2)
and remove it from
the machine. Hand-
wash the filter in cold
water
The pre-motor and post-motor filters may be hand-washed in cold water.
Rinse well and air-dry thoroughly before replacing.
Do not operate cleaner with damp or wet filters or without all filters in place.
10
2
2.1
3.1
3
2.2
3.2