TVS Scooty Zest User Manual page 56

Even though, if there is need of tyre removal, it is
strongly recommended to use a tyre removal / fitment
machine. If at all, tyre levers needs to be used, the
levers should be free from sharp edges. Care should
be taken not to damage the tyres and rims.
The tyre inflation pressure in cold condition and the
tyre tread condition are extremely important for the
performance and safety of the rider. Check the tyres
frequently for inflation pressure as well as the wear
pattern on it. Use of a tyre other than the standard may
cause instability.
The side walls of the tubeless tyre which in contact with
the wheel rim are only seals the air inside the wheel
assembly. Hence care should be taken not to damage
the side walls of the tyres during removal / reassembly.
FRONT WHEEL REMOVAL
1. Remove the axle nut (1) along with a washer. Take
out the cover fork tube RH .
2. Pull out the axle (2) along with punched washer
and take out the cover fork tube LH.
3. Take out the spacer from the right side of the
wheel. Dislocate the hub drive from wheel hub.
4. Place a support below the foot board to prevent
vehicle from falling and lift the vehicle up.
5. Dislocate the wheel assembly along with brake
panel from front fork. Separate the brake panel
from the wheel and take out the wheel.
1 2
43