Table of Contents
Advertisement
Quick Links
Operation Manual
Air Compressor
61018
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for WilTec 61018
Summary of Contents for WilTec 61018
- Page 1 Operation Manual Air Compressor 61018 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
-
Page 3: Operating And Safety Instructions
Do not store the compressor outdoors and protect it from direct sunlight. Make sure that all open connections are closed with protective caps during transport in order to prevent dirt and water from entering. © by WilTec Wildanger Technik GmbH Item 61018 Page 3 http://www.WilTec.de http://www.aoyue.eu 11 2020-1 http://www.teichtip.de... -
Page 4: Technical Data
Turn clockwise to increase the air pressure and turn counterclock- wise to decrease it. Note: Always pull the plug and disconnect the compressor from the power source be- fore carrying out any adjustments or repairs/maintenance. © by WilTec Wildanger Technik GmbH Item 61018 Page 4 http://www.WilTec.de http://www.aoyue.eu... -
Page 5: Repair And Maintenance
The compressor tank must be checked every two years. Check the outside as well. If there are rusted areas on the tank or if the tank does not pass the pressure test, the tank must be scrapped. © by WilTec Wildanger Technik GmbH Item 61018 Page 5 http://www.WilTec.de http://www.aoyue.eu... -
Page 6: Troubleshooting
Valve flap fault or leak Clean or replace Wear and tear on the piston rubber cup Replace the piston rubber cup. © by WilTec Wildanger Technik GmbH Item 61018 Page 6 http://www.WilTec.de http://www.aoyue.eu 11 2020-1 http://www.teichtip.de... - Page 7 Explosion drawing and parts list © by WilTec Wildanger Technik GmbH Item 61018 Page 7 http://www.WilTec.de http://www.aoyue.eu 11 2020-1 http://www.teichtip.de...
- Page 8 Hexagon socket crews (flat point) M8X10 Ball valve Right case Pressure switch Lap hoop Y40 pressure gauge Hexagon socket head cap screws M5X150 Adjustable oil-water separator Flat gasket Safety valve © by WilTec Wildanger Technik GmbH Item 61018 Page 8 http://www.WilTec.de http://www.aoyue.eu 11 2020-1 http://www.teichtip.de...
-
Page 9: Disposal Regulations
All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste. -
Page 10: Eg-Konformitätserklärung
EN ISO 12100 :2010, EN 1012-1 :2010 EN 60204-1 :2006+A1 :2009+AC :2010 EN 61000-6-1 :2007, EN 61000-6-3 :2007+A1 :2011+AC :2012 EN 61000-3-2 :2014, EN 61000-3-3 :2013 Bevollmächtigter für die Zusammenstellung der technischen Unterlagen: Bernd Wildanger, Geschäftsführer WilTec Wildanger Technik GmbH Königsbenden 12 52249 Eschweiler Deutschland Eschweiler, 06. Juni 2016 Gültig bis 05. Juni 2021...
Need help?
Do you have a question about the 61018 and is the answer not in the manual?
Questions and answers