Table of Contents
Advertisement
Quick Links
Operation Instructions
Airbrush
Diaphragm Compressor AS09
ARTICLE 34224
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ
insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
© by WilTec Wildanger Technik GmbH
Seite 1
http://www.wiltec.info
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for WilTec AS09 34224
Summary of Contents for WilTec AS09 34224
-
Page 1: Operation Instructions
Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us. © by WilTec Wildanger Technik GmbH Seite 1 http://www.wiltec.info... - Page 2 The user is responsible for complying with the location specific safety and mounting regulations (you can ask an electrician) In case of device failure the repairs can be carried out only by an electrician or by the WilTec- repair service © by WilTec Wildanger Technik GmbH Seite 2 http://www.wiltec.info...
- Page 3 It can also be employed for inflating tyres (bicycle, motorcycle, car) and balloons. The constant and sufficient output is achieved by means of diaphragm that has the multiple life of classic piston. High spray quality almost noiseless working and low weight characterise the energy-saving diaphragm compressor. © by WilTec Wildanger Technik GmbH Seite 3 http://www.wiltec.info...
- Page 4 The pressure level depends on the other hand on the nozzle diameter of the airbrush to which is connected; the bigger the nozzle diameter is, the larger the air quantity that can escape and the lower the working pressure of the compressor. © by WilTec Wildanger Technik GmbH Seite 4 http://www.wiltec.info...
- Page 5 2. The valve was destroyed, position. because the work has been done 2. Replace the valve or the cylinder for too long with very high cover. pressure. © by WilTec Wildanger Technik GmbH Seite 5 http://www.wiltec.info...
- Page 6 Part list © by WilTec Wildanger Technik GmbH Seite 6 http://www.wiltec.info...
- Page 7 All Wiltec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.
- Page 8 When evaluating the product according to the EU demands, the following standards were applied: EN 60335-1:2002 EN 60335-2-34:2002 If the product is changed this declaration loses its validity. Eschweiler, 06. Juni 2006 __________________________ Bernd Wildanger Manager © by WilTec Wildanger Technik GmbH Seite 8 http://www.wiltec.info...
Need help?
Do you have a question about the AS09 34224 and is the answer not in the manual?
Questions and answers