Kalor Francesca 17B User Manual page 45

PROBLEM
Pellet build up in grate,
door glass gets dirty
and flame is weak
The smoke extraction
motor does not work
The air fan convention
never stops
In the automatic
position the
thermostove always
runs at full power
The thermostove starts
up "alone"
The power does not
change even if you
manually adjust
Anomalies related to the plumbing circuit
PROBLEM
No increase in
temperature with
Thermostove in
operation
Condensation
in thermostove
POSSIBLE CAUSE
1. Insufficient combustion air
2. Pellets damp or unsuitable
3. Smoke extractor motor broken
4. Bad adjustment. Wrong ratio
between air and pellet
1. No electrical supply to
the thermostove
2. The motor is broken
3. Defective electronic board
4. Control panel broken
1. Temperature sensor temperature
control defective
or broken
2. Fan failure
1. Room thermostat
maximum
2. Temperature sensor defective
3. Control panel defective or
broken
1. Incorrect programming of the
cronothermostat
1. The board is set to automatic
correction of power in proportion
to the temperature
POSSIBLE CAUSE
1. Incorrect combustion
adjustment
2. Thermostove/system dirty
3. Insufficient Thermostove power
1. Incorrect setting maximum
water temperature in the
thermostove
2. Insufficient fuel consumtion
REMEDY
1. Check that the room air intake is present and free.
Check that the pipe Ø 5 cm for air inlet is not
obstructed.
Clean the grate and check that all the airways are clear.
Carry out a general cleaning of the combustion
chamber and the smoke duct.
Check the state of the door gaskets
2. Change the type of pellet
3. Check the motor and replace if necessary
4. Contact your Authorized Assistance Center
1. Check the supplay voltage and the protection fuse
2. Check the motor and capacitor and replace
if necessary
3. Replace electronic board
4. Replace the control panel
1. Check operation of the sensor and replace
if necessary
2. Check operation of the motor and replace
if necessary
set to
1. Reset the thermostat temperature
2. Check the operation of the sensor and replace if
necessary
3. Check the panel and replace if necessary
1. Check the settings of the cronothermostat
1. Contact your Authorized Assistance Center
REMEDY
1. Check parameters
2. Check and clear the thermostove
3. Check that the Thermostove is properly sized for the
requirements of the system
1. Set the Thermostove to a higher temperature. The
maximum water temperature in the thermostove is 65
° C and can not be set below 40 ° C or above 80 ° C.
It is advisable to never adjust the temperature below
50/55 ° C to avoid condensation in the thermostove.
Adjust the power of the pump at a higher
temperature to 50/55 ° C.
2. Contact your Authorized Assistance Center
43