Table of Contents
Advertisement
MAINTENANCE
WARNING
Make sure to disconnect the
power before cleaning the
product.
(Otherwise, the product might operate with
the possibility of electric shock or injury.)
Do not operate the product when the
composite and deodorizing filter is removed.
(The composite and deodorizing filter cannot
function while it is removed. Dust will be
inhaled into product inner parts, and causes
the product breakdown. )
Dirt sensor
(about once every 3 months)
Wipe the dirt off the lens with a dry
cotton swab
Remove the cover of dirt sensor as shown
below.
Wipe the lens with a dry cotton swab as
shown below.
Wipe the lens periodically.
(The sensor may not function normally with
accumulation of moisture and smoke from
cigarette.)
Do not insert a cotton swab in other parts.
Be sure to disconnect power before cleaning.
You can use a light in order to see lens
clearly.
16
Cleaning method
3
1
Lens(top left and
top right)
Dry cotton swab
Notice
Do not use the
detergents
shown on the
right.
When using chemically treated cloth, make
sure to follow the instructions carefully.
When maintenance, do not leave the removed
parts unattended.
(Otherwise, it may cause tripping or damage.)
Body and Front panel
(about once a month)
Wipe off any dust and dirt using a well
wrung-out soft cloth
Check page 8 to 10 for opening and closing
methods.
8 ~ 10
Do not wipe it with a hard cloth or hardly.
Otherwise, the surface may be damaged.
Pre-filters
(about once a month)
Wash with water
Pull out horizontally. (when installing, Insert
horizontally until it reaches the end)
Soak a soft cloth in warm water or water
with a neutral kitchen detergent, then scrub
to remove the stain.
Polish
1
Advertisement
Table of Contents
