Download  Print this page

Advertisement

Thank you very much for purchasing this Panasonic product.
Please read these operating instructions carefully before operating or servicing the product.
Failure to comply with instructions could result in injury or property damage.
Keep the operating instructions in a safe place for future reference.
OPERATING INSTRUCTIONS
Model No.
CONTENTS
Air Purifier
F-PXL45A
This product is for indoor use only
BACK COVER
3 ~ 5
5 ~ 6
6
7
8 ~ 9
10 ~ 13
10
11
12
12 ~ 13
14 ~ 15
14 ~ 15
15
15
16 ~ 17
18
19

Advertisement

Table of Contents

   Also See for Panasonic F-PXL45A

   Related Manuals for Panasonic F-PXL45A

   Summary of Contents for Panasonic F-PXL45A

  • Page 1: Table Of Contents

    SPECIFICATIONS/ OPTIONAL ACCESSORIES BACK COVER Thank you very much for purchasing this Panasonic product. Please read these operating instructions carefully before operating or servicing the product. Failure to comply with instructions could result in injury or property damage. Keep the operating instructions in a safe place for future reference.
  • Page 2 [Test number 13044083003-01] hours(Test number 24_0301_1) With a variety of bacterica to test Test organization: Panasonic Corporation Analysis Center Test method: measure the allergens adhered on the fabric in a test space of 23m with ELISA method Inhibiting method: release nanoe...
  • Page 3: Safety Precautions

    With function of “detecting, indicating and removing PM2.5” The product can detect PM2.5 (0.3 ~ 2.5µm particles) in air by dirty sensor and remove them by HEPA composite filter. The PM2.5 pollution indicator will be red when the pollution is serious. With “ECONAVI”...
  • Page 4 SAFETY PRECAUTIONS Please follow strictly WARNING Do not place your fingers or In case of any abnormality or metal objects into the air inlet malfunction, stop using the or air outlet. product immediately and (Otherwise, you may be hurt by the disconnect the power.
  • Page 5: Setting And Operating Requirements 5

    SAFETY PRECAUTIONS Please follow strictly CAUTION Do not clean the product with Do not place the product in gasoline or other volatile mix- the following places. ture solvents, and avoid con- Do not place in incline and unstable place. tacting with spray insecticides. (Otherwise, the prouduct may fall over (Otherwise, the product may crack or and injury may occur.)
  • Page 6: Accessories

    SETTING AND OPERATING REQUIREMENTS The remote receiver should not be exposed directly to sunlight or the glare of lighting appliance. (Otherwise, the remote control may be difficult to operate.) A magnet is installed at the upper left corner of the product. Always keep items, such as watch, credit card away from Area of the this product.
  • Page 7: Main Parts Identification

    MAIN PARTS IDENTIFICATION Front Back Air outlet (nanoe outlet) Odor sensor Control panel Handle (left and right) Display Power cord panel guiding clip Front panel Air inlet Power plug (both sides) Power cord Air inlet (front) Air pollution indicator Dirt sensor Deodorizing filter Body Front...
  • Page 8: Setup

    SETUP Before startup Install filters Fill in the label with Remove the deodorizing the first date of use. filter from the poly bag. Remove the front panel. Front panel F-ZXLP45Z F-ZXLD45Z Pull then push up with both hands Toggle the filter hook upward, and remove the filters.
  • Page 9: Setup

    SETUP Power-on Install filters Insert the Install the filters and front panel. power plug. Toggle the filter hook Install the deodorizing filter. downwards, and secure the (There is no difference between sides and direction.) filter. Filter hook (Turn down) Filter fixed rib As the odor sensor detects the cleanliness after the Deodorizing filter...
  • Page 10: Operation 10

    OPERATION POWER OFF/ON CONTROL Control panel Power Off/On ECONAVI button Child lock button Timer button Air volume button button Display panel Remote Filter replacement Air volume Sleep Child lock receiver indicator indicator indicator indicator nanoe indicator Timer PM2.5 pollution Light ECONAVI Light indicator...
  • Page 11: Air Volume Selection·timer Operation·child Lock

    OPERATION AIR VOLUME SELECTION · TIMER OPERATION · CHILD LOCK Air volume selection Select appropriate air volume for purifying air. The air volume indicator will be changed sequentially as figure below. (Automatically adjust the air volume according to the Auto air pollution detected by sensor, and use the best air volume to purify air.) (Indicator...
  • Page 12: Econavi

    OPERATION ECONAVI · REMOTE CONTROL ECONAVI Smart power-saving mode. ECONAVI is a smart power-saving operation by combining the “patrol mode” with “learning mode”, and adjusts the air volume automatically. (P.17) Notice Press the button again to cancel the ECONAVI operation, and indicator lights off. (Indicator When press button, ECONAVI...
  • Page 13 OPERATION REMOTE CONTROL Remote control Method of changing battery (Panasonic CR2025 is recommended.) Use your nail to push to right ※ The battery life is about 1 year. and hold at ① position, at (Assuming that the button is pressed 20 times every day.) the same time pull battery holder out at ②...
  • Page 14: Care And Maintenance 14

    CARE AND MAINTENANCE Cleaning method Notice Be sure to disconnect the power before Do not use the detergents shown below. cleaning the product. When remove and install the front panel, the remote control may fall off, please take off the remote control first before clean.
  • Page 15: Filter Replacement

    CARE AND MAINTENANCE Cleaning method Filter replacement (Optional accessories: back cover) Dirt sensor HEPA composite Deodorizing < about once every 3 months > filter filter Wipe the dirt off the lens with a dry When the filter exchange indicator Replacement cotton swab lights up.
  • Page 16: Further Information 16

    FURTHER INFORMATION About “nanoe ” nanoe can be switched off. During operation, press and hold the for about 3 seconds, then the nanoe indcator turns off. Perform the same operation again to restart the nanoe nanoe Conditions for generation nanoe is generated using the air in the room and hence, depending on the temperature and humidity, therefore, nanoe may not be generated stably.
  • Page 17 FURTHER INFORMATION About sleep mode auto operation Sleep mode auto operation refers to detects the indoor brightness by the light sensor, and automatically adjusts the brightness of indicators and the air volume . When sleeping, the room becomes dark, the indicators light half on or light off and the air volume becomes low.
  • Page 18: Faqs

    FAQS Please confirm the following before you put questions forward or send the product for repair. When a “jee” sound is heard from The air pollution indicator turns off the emission outlet? during operation. Detects the indoor brightness, and There is a slight sound when nanoe adjusts the brightness of the air pollution taking place.
  • Page 19: Troubleshooting

    TROUBLESHOOTING If a probem is encountered, investigate it by referring to the tabel below. If the problem still persists, please disconnect the power and contact the dealer for repair. Possible situation Please confirm the following The indicator may illuminate red when the product is subject to The air pollution indicator remains red even when steam in the bathroom or vapor emitting from sprayers.
  • Page 20: Specifications/ Optional Accessories

    Part No.: Part No.: Call the dealer The air volume indicator is blinking. Product may be out of order. Please disconnect the power and contact the dealer for repair. Panasonic Corporation Web site: http://www.panasonic.com PXL4A8952BC © Panasonic Corporation 2015 P0915-2095...

Comments to this Manuals

Symbols: 0
Latest comments: