Gree FLEXX36HP230V1AO Installation & Owner's Manual page 26

DC Inverter Series for R410A Unitary Split Air Conditioner
Wires of outdoor units
Single-phase unit: FLEXX36HP230V1AO, FLEXX60HP230V1AO.
High and low voltage wires should be led through different rubber rings of the
①.
electric box cover.
Do not bundle up the thermostat wires or lay them side by side, otherwise
②.
errors will occur.
High and low voltage wires should be secured separately. Secure the former
③.
ones with big clamps and the latter ones with small clamps.
Use screws to tighten up the thermostat wires and power cords of the units on
④.
the terminal board. Wrong connection may lead to fire hazard.
If the thermostat wires of the units and power cords are not correctly
⑤.
connected, the air conditioner may get damaged.
Ground the units through connecting the ground wire.
⑥.
The units should comply with applicable local and national rules and
⑦.
regulations on power consumption.
When connecting the power cords, make sure the phase sequence of the
⑧.
power supply matches with the corresponding terminals, otherwise the
compressor will get reversed and operate abnormally.
21