Gree FLEXX36HP230V1AO Installation & Owner's Manual page 24

DC Inverter Series for R410A Unitary Split Air Conditioner
3.3.2 Electrical Parameters
Model
FLEXX36HP230V1AO
FLEXX60HP230V1AO
3.3.3 Connection of Power Cords and Thermostat Wires
(1)
For solid wires (as shown below):
1) Use wire cutters to cut off the wire end and then peel away about 25mm
of the insulation layer.
2) Use a screwdriver to unscrew the terminal screw on the terminal board.
3) Use nippers to bend the solid wire into a ring that fits the terminal screw.
4) Form a proper ring and then put it on the terminal board. Use a
screwdriver to tighten up the terminal screw.
(2) For stranded wires (as shown below):
1) Use wire cutters to cut off the wire end and then peel away about 10mm
of the insulation layer.
2) Use a screwdriver to unscrew the terminal screw on the terminal board.
3) Use a round terminal fastener or clamp to fix the round terminal firmly
on the peeled wire end.
4) Locate the round terminal conduit. Use a screwdriver to replace it and
tighten up the terminal screw (as shown below).
Power supply
208/230V-
1Ph-60Hz
208/230V-
1Ph-60Hz
Maximum
Fuse
overcurrent
capacity
protection
(A)
35
45
19
Minimum
circuit
ampacity
(A) (A)
35 24
45 35