Huawei FusionPower6000 Quick Manual page 2

Hide thumbs Also See for FusionPower6000:

Removing Mounting Ears from the Base and Protective Parts

1. Cut open the protective covers using a utility knife and remove the protective covers.

2. Remove mounting ears from the base and protective parts.

Grounding a PowerPOD

Connect the ground cables to the ground points of the PowerPOD using M8/M6 stainless steel bolt

assemblies. Route the ground cables through plastic-coated metal hoses based on site

requirements.

Installing Devices Inside a PowerPOD

1. Move power modules to the reserved positions in the UPS. Rotate the ready switches to the

locked state. Secure the power modules.

FusionPower6000 V100R021C10 Quick Guide

2. Move an SVG module to the reserved position in the SVG cabinet. Install and secure the

SVG module.

Installing Cables

1. Connect input power cables to the transformer and the dense busway of the bus tie cabinet.

2. Remove the top cover and the rear panel from the feeder cabinet as required.

Connect output power cables.

3. Install battery cables for the UPS.

（1）Connect the ground cable of the battery

string or its BBB box to the battery PE of the UPS

or the ground bar in the equipment room as

required.

V100r021c10