Related Manuals for Labgear SQ722
Summary of Contents for Labgear SQ722
- Page 1 Digital Satellite Signal Quality Finder Set Up Instructions Find the Right Transponder, on the Right Satellite, First Time. Every Time. DVB-S2 SQ722...
- Page 2 4. SATELLITE Satellite Button Note: the Satellite button defaults to position 1 - Service 1 each time SQ722 starts up. Service 1 is for VAST and PayTV, use of Satellite button is unnecessary. To change, press the Satellite button repeatedly: 1 Beep is for Service 1 - Optus 10/D3 at 156°E...
- Page 3 6. ELEVATION BLACK Following the lines on the graph, set the Satellite Dish elevation. For example: in Melbourne, the elevation would be approximately 45 degrees. Elevation Bolts Elevation Markings 45 Degrees Melbourne SQ722 IS LAB SQ722 0520.PDF | P 2-5 |...
- Page 4 9. SIGNAL Looking at the instrument, there are 2 lines of LEDs. GREEN lights represent Signal Quality. RED lights represent Signal Level. Signal Quality shows clearly when you have the right Satellite! SQ722 IS LAB SQ722 0520.PDF | P 3-5 |...
- Page 5 If you start with a slightly higher elevation, as you pan the Satellite Dish side to side, slightly lower the Satellite Dish after each pass in 1 Degree increments, you are sure to LOCK the correct Satellite. SQ722 IS LAB SQ722 0520.PDF | P 4-5 |...
- Page 6 Disconnect the SQ722 reconnect coax cable directly between your Satellite Dish and Receiver. As SQ722 is a pre-programmed tool, signal does fully pass through. 16. All that is left to do is sit back and enjoy your Satellite reception! SATELLITE DISH ALIGNMENT COMPLETE SQ722 IS LAB SQ722 0520.PDF | P 5-5 |...
- Page 7 Digital Satellite Signal Quality Finder DVB-S2 SQ722...