Return Suction Strainer - HAKO -Citymaster 1800 TDI Instruction Manual

Change the oil as described below :
run engine to warm oil
lift hopper and secure with jackbar
Note : you may also lift the hopper
with the manual pump (refer to page
59)
drain hydraulic oil by removing the
drain plug (VII/4) and collect the
used oil in an appropriate recipient.
re-insert drain plug
fill fresh oil through filler (VII/1) until
floater appears at the upper end of
the gauge glass (VII/2) until float
appears at upper end of gauge
glass.
Note: use clean oil only which was
stored in approved and sealed con-
tainers.
Collect oil and dispose of in compli-
ance with local regulations.
Replace oil filter at each oilchange.
64
1 tank cap / filler neck
2 gauge glass
3 return suction filter
4 drain plug (spanner size 17)
Return suction filter
The return suction filter (VII/3) is loca-
ted on the hydraulic oil tank. This filter
element has to be replaced after the
first 75 hours of operation. Then repla-
ce as required, i.e. if the indicator at
the dashboard lights.
In the hydraulic tank, additional suc-
tion sieves are located. They may be
unscrewed and checked at each
hydraulic oil change. Proceed to
inspection via the filter opening in the
tank.
VII