Stop Machine, Shut Down Engine; Sweeping - HAKO -Citymaster 1800 TDI Instruction Manual

Never run engine in an indoor
location.
Note: when engine fires, engine oil
pressure light and charge light have to
dim.
At temperatures below 0 °C allow the
engine after firing to run idle for at
least 5 minutes and at temperatures
below-10°C for at least 15 minutes to
warm-up.
Before machine starts rolling make
sure the hopper is in low position
(check pilot light) and check whether
surrounding is clear of persons (chil-
dren). Maintain good visibility, never
leave driver's seat while machine is
rolling.
adjust direction and speed of travel
with control stick
forward travel, 1 speed
= 0 to 30 km/h
forward travel, 2 speed
= 0 to 50 km/h
slowly depress accelerator pedal,
machine starts rolling
58
Stop machine,
shut down engine
return accelerator to neutral
actuate brake pedal if hydrostatic
brake action is insufficient
when machine comes to standstill,
actuate parking brake.
Note : Parking brake won't open
unless engine is running !
return selector stick to neutral.
shut engine down
Note : do not attempt to shut
engine down in an high rpm
situation.
Before leaving the machine:
lower sweeping attachment,
secure machine against unintended
movement, e.g. by closing the parking
brake,
pull ignition key
lock cabin doors.

Sweeping

take the following actions before
sweeping:
lower hopper
Note : do not use any water at tem-
peratures below freezing point.
Drain residual water from tanks and
pump.
fill fresh water tank
open both hose couplings, connect
hose
fill tank until water starts overflowing
at the forward RH end of the tank.
Capacity approx. 380 litres.
fill recirculating water tank; open
rear hopper flap and fill water until
filter screen in bottom of hopper is
covered
close and lock rear flap
set all controls to neutral or zero
actuate brake pedal
start engine, refer to "drive the
Hako-Citymaster 1800 TDI"