Advertisement

Quick Links

IQN/F
MODELS
-
IQF FLAKER
-
IQN NUGGETS
USER MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IQF FLAKER and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ITV ICE MAKERS IQF FLAKER

  • Page 1 USER MANUAL IQN/F MODELS IQF FLAKER IQN NUGGETS...
  • Page 2: Table Of Contents

    ENGLISH- CONTENTS 1. INTRODUCTION ......................... 3 WARNINGS (tamaño de letra al menos 3,2 mm sólo para este punt) ......3 2. RECEIVING THE MACHINE ...................... 4 2.1.- PACKAGING ........................4 2.2.- EXTERIOR OF THE EQUIPMENT ..................4 2.3.- DETAILS PLATE........................4 3.
  • Page 3: Introduction

    ENGLISH 1. INTRODUCTION Thank you for buying an ice cube maker from our 'NIQ' range. You have bought one of the most reliable ice makers on the market today. Carefully read the instructions within this manual, these contain important information regarding safety during installation, operation and maintenance.
  • Page 4: Receiving The Machine

    ENGLISH In case of refrigerant leakage: Do not generate flames close to the appliance. Do not switch on/off or plug in/off the appliance. To ventilate immediately the area where appliance is located by opening doors and/or windows. To call to an authorized technical service. 2.
  • Page 5: Installation

    ENGLISH 3. INSTALLATION THIS ICE MAKER IS NOT DESIGNED FOR OUTDOOR OPERATION. An incorrect installation of the equipment may cause damages to individuals, animals or other materials, being the manufacturer not responsible for such damages. 3.1.- SITE CONDITIONS ATTENTION: The IQ machines are designed to operate at room temperature between 10ºC (50ºF) and 43ºC (109.40ºF).
  • Page 6: Electrical Connection

    ENGLISH 3.4.- ELECTRICAL CONNECTION IT IS MANDATORY TO GROUND THE EQUIPMENT To avoid possible discharges on individuals or damages to the equipment, the machine should be grounded pursuant local and/or national regulations as the case may be. THE MANUFACTURER SHALL BE HELD HARMLESS IN CASE OF DAMAGES ARISING DUE TO THE LACK OF THE GROUND INSTALLATION At the back of the machine there is a junction box for electrical service conexion.
  • Page 7 ENGLISH Figure...
  • Page 8: Control Panel

    ENGLISH 4. CONTROL PANEL The outer panel is located at the front of the machine, in the upper left corner and has 5 buttons: Figure Figure 4.1. PE1.- ON/ OFF BUTTON When turning on the rear switch of the machine, PE1 will be red, which means that the machine will be in the stand by mode. Pressing the PE1 button will enter the timing state and the LED will light up with a flashing blue.
  • Page 9: Start Up

    ENGLISH 5. START UP 5.1. PREVIOUS CHECKUP a) Is the machine leveled? b) Voltage and frequency are the same as those on the nameplate? c) Are the discharges connected and operating? d) ** If air condensed: Is the air circulation and its temperature appropriate? ROOM WATER MAXIMUM...
  • Page 10: Maintenance And Cleaning Instructions

    ENGLISH 6. MAINTENANCE AND CLEANING INSTRUCTIONS You must wear rubber gloves and safety goggles when handling the cleaner or Sanitizer for the ice machine. All ice that will be made during this procedure is not suitable for human consumption, so it must be melted or discarded. *Maintenance procedures described in this manual are not covered by the warranty* 6.1.
  • Page 11: Removing Residues Procedure

    ENGLISH 6.3 REMOVING RESIDUES PROCEDURE 1. In order to make sure that there is no residues that could have remained in the machine, rinse the water reservoir cover (A) and the ice outlet Cover (C) with water and place these items in its respective position. 2.
  • Page 12 FLAKES NUGGET...

This manual is also suitable for:

- iqn nuggets

Table of Contents