Configuration Cable; Introduction; Appearance; Wiring - Raisecom iTN201-R Hardware Description

Raisecom
iTN201-R (C) Hardware Description
1PPS+TOD (1)
1PPS+TOD (2)
1PPS
The clock cable is not delivered with the iTN201-R. You can make or order one as
required.

5.5 Configuration cable

5.5.1 Introduction

The configuration cable is used to connect the Console interface on the iTN201-R to the RS-
232 serial interface on the maintenance console, transmitting configuration data. You can
debug and maintain the local device through the Console interface on the maintenance
console.
The connectors at both ends of the configuration cable are as below:


Before accessing the iTN201-R through the USB interface, install the driver on the
PC for converting the USB interface into the Universal Asynchronous
Receiver/Transmitter (UART) interface. To download the driver, visit
http://www.raisecom.com.cn/support.php and then click USB_Console_Drive.

5.5.2 Appearance

Figure 5-8 shows the appearance of the configuration cable.

Figure 5-8 Configuration cable

5.5.3 Wiring

Table 5-10 shows terminal PINs and wiring.
Interface
Not equipped
Not equipped
Not equipped
USB: connecting the USB Console interface
USB: connecting the USB interface on the maintenance console
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Cable
You can make it according to the clock PIN.
You can make it according to the clock PIN.
The local end connector is equipped with the type
of 50Ω-long BNC header-straight-female
interface/RoHS. You can make the cable by
yourself.
5 Fiber and cables
Description
51