E1 Cable; E1-Rj45 Cable; Figure 5-6 Cbl-E1-Rj45/Rj45 E1 Balanced Cable; Table 5-4 E1-Rj45 Cable - Raisecom iTN201-R Hardware Description

Raisecom
iTN201-R (C) Hardware Description

5.3 E1 cable

5.3.1 E1-RJ45 cable

Introduction
The iTN200-PWE3-8E1-BL provides the RJ45 E1 interface. One RJ45 interface transmits 2
ways of E1 signals, which is connected through the E1-RJ45 cable, as listed in Table 5-4.

Table 5-4 E1-RJ45 cable

CBL-E1-RJ45/RJ45
CBL-E1-RJ45/2RJ45
The E1-RJ45 cable is not delivered with the iTN201-R. You can make it on site as
required. The appearance and wiring described in this section are for your reference
to make the E1-RJ45 cable.
Appearance
Figure 5-6 shows the appearance of the CBL-E1-RJ45/RJ45 E1 balanced cable.

Figure 5-6 CBL-E1-RJ45/RJ45 E1 balanced cable

Figure 5-7 shows the appearance of the CBL-E1-RJ45/2RJ45 E1 balanced cable.
Model
One RJ45 interface is connected with one RJ45 connector to
transmit 2 ways of E1 signals.
One RJ45 interface is connected with two RJ45 connectors to
transmit 2 ways of E1 signals. One RJ45 connector is
connected with the E1 interface of the TDMoP card to carry 2
ways of signals. Both RJ45 connectors are connected to E1
interfaces of the TDM device for carrying 1 way of signals
respectively.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
5 Fiber and cables
48