Huawei FusionDC1000A Quick Manual page 36

Device Name
11D ATS
8D ATS
3D ATS
SMU05A
UPS5000-A
UPS2000-G
UPS5000-E
UPS5000-S
Integrated UPS
BCB
MCCB
Inverter
AC PDF
ETP4830
Note: The following device parameters are not all parameters of the devices. Only the parameters that need to be set for the project are listed. Default values will be used for the other parameters
so they do not need to be set. To view other device parameters, see the user manual for the corresponding device.
If voltage/frequency settings for power distribution devices are involved, adjust the voltage and frequency settings based on the local voltage system and check whether the voltage thresholds and
frequency hysteresis meet setting requirements before first operation.
Table 1 Initial Configuration Parameters for Power Supply and Distribution Devices
Project Configuration
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
■Involved □Not involved
Quantity Power Distribution Device Name Remarks
Pyromagnetic MCCB; this part is
used for setting parameters in
the assembly factory. It is not
included in the document.