Table of Contents
Advertisement
Available languages
Available languages
Refer to the diagrams for assembly.
• Place the motor unit on a smooth, stable surface to prevent scratches.
• Turn the drum over and
insert the wheels into the
holes
on
the
exerting
some
pressure,
and
check
that
support the weight; make
sure the internal vacuum
hose is correctly positioned in its place
• Pour enough water into the drum to reach the maximum water level indicated as
"
WATER MAX LEVEL
maximum level. The appliance must always run with water in the tank. Be very
careful when moving the appliance when the tank contains water.
• To open the filter cover, rotate
counter-clockwise and make sure
that the HEPA filter is correctly
inserted and locked securely in
place (if not, position it in its
place and turn clockwise to
secure it). Position the
cover in its slot (teeth must be inserted into their respective slots) and turn the
cover clockwise; once this has been done, check that the cover is properly secured.
• Unravel the electrical cord from its position
(cable around the motor unit).
• Place the motor unit on the drum, so that
the internal vacuum hose enters the filter
cover slot; secure it using the clips (press
down to lock). Shake slightly by hand to
ensure that the motor unit and drum are
properly secured.
• Connecting the flexible hose: line up the clips of the
flexible hose to the slots of the suction nozzle, insert the
tube (A) and rotate clockwise (B) until it locks. To
disconnect the hose, repeat in the opposite direction
(turn the flexible hose counter-clockwise and pull out
the hose).
• To
the
flexible
handle (22) attach the
most suitable accessory
(hoses, brush or nozzle).
Insert it all the way to
secure correctly.
bottom,
all
4
"
printed on the drum (about 3 litres). Do not fill above the
hose
17/52
Advertisement
Table of Contents
