Table of Contents
Advertisement
3.3.7
Foot Pedal
The foot pedal
(Figure 3.3-8)
have both hands free to look after the patient (e.g. Dix Hallpike). Connection with the PC is via a USB port.
Figure 3.3-8 VisualEyes™ Foot pedal
3.3.8
VisualEyes™ remote control
The remote control
(Figure 3.3-9)
VisualEyes™ suite. The operator can operate the software using the remote control while remaining at the
patient's side during testing. The remote control's receiver connects to the PC via a USB port, while the remote
control connects to the receiver using 2.4 GHz rf transmission.
1. Top button:
Centers eyes (top mount goggles only)
•
2. Right button:
Typically, this can perform any command in VisualEyes which is selected (indicated with white background).
Please find the below example for better explanation:
Before calibration, one can command to select 'Calibration' option which is shown
in white background.
After calibration, one can command to select 'START' option which is shown in
white background.
This way, the operator can perform below listed actions.
Goes forward in the software
•
Launches calibration
•
Following calibration, button will start the test
•
If the test is running, it stops the test
•
If in playback mode, the button will advance to the next test in the
•
list
3. Left button:
Stops the test
•
4. Bottom button:
Turns on/off the fixation light during a test
•
D-0126472-A – 2020/08
VisualEyes™ 505 Instructions for Use -US
allows you to begin the measurement testing by pressing the foot switch so you
provides a hand held option for controlling and performing tests within the
Figure 3.3-9 VisualEyes™ Remote Control
Page 14
Advertisement
Table of Contents
