Q-tran QTM-eLED+DMX Installation Instructions Manual page 5

QTM - eLED+DMX
Connecting &
Connecting and configuring the LINEARdrive 100D/180D
DMX in shield
DMX in -
Ext in -
DMX in +
Ext in +
Primary Wiring
GND
NEU
HOT
Secondary Wiring
TC
LED supply +
Group 1
Group 2
Group 3
Group 4
Black Wire = +24V
Red Wire = Red LED
Green Wire = Green LED
- +
Blue Wire = Blue LED
M
White Wire = White LED
WARNING:
Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION:
The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and building codes must be observed.
Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
● DMX Shield must be grounded to Earth Ground at a single point external to power supply
© 2020, Q-Tran Inc. 155 Hill St. Milford, CT 06460. All rights reserved - 203-367-8777 - sales@q-tran.com - www.q-tran.com
To DMX Controller
LedSync shield
LedSync thru -
Ext in -
LedSync thru +
Ext in +
GND
HOT
NEU
Configuration
W B G R +24
LED
Blue Wire = Blue LED
Red Wire = Red LED
Green Wire= Green LED
White Wire = White LED
Black Wire = +24V W B G R +24
Red DMX +
Blue DMX -
Green GND
Commonly Asked Questions
1) How can I verify my installation?
● Apply AC input, verify display turns on : This confirms AC input wiring
● Run "Visual Test Run" : This verifies wiring of LEDs. Make sure LEDs turning on go in
same order as the Test Run
2) I don't have a controller yet, how can I keep my lights on?
● Change the Mode to "COLR" : This allows to manually set a specific color to be on
● Adjust the Hue or WHIT to achieve the desired color : This sets that specific color
3) My LEDs aren't coming out the right color. They look like white has been added in
● Verify the Network Resolution "NETW RES" : Default is 8 BT
● Check your DMX Programming. Stick controllers come with RGB programs by default.
This will cause RGBW LEDs to show Pink vs. Red
Control Wiring
DMX connections
LedSync shield
LedSync thru -
LedSync thru +
DMX in shield
DMX in shield
DMX in -
DMX in +
DMX in -
DMX in +
Instruction
LED DRIVER 2
(120 - 277V)
DMXIN DMXOUT
A B C
DMXOUT DMXIN
To next
power
supply
DMX Shield
DMX -
DMX +
SECONDARY
PRIMARY
LED DRIVER
(120 - 277V)
GND
HOT
NEU
4