Changing The Water In The Boiler (Only Dt Version With Display); Cup Warmer (Where Applicable) - La Cimbali M26 Use And Installation

12. Changing the water in the boiler (only DT version with display)

The water in the boiler must be changed at least
once a day.
NOTE: the "WATER CHANGE" function can be
programmed by the technical personnel: in this case, the
request message appears at the time set and the water
change cycle cannot be interrupted.
Ensure that the indication on the display (where present)
corresponds to the working pressure value.
Keep the hot water distributor key (11) pressed down for
approximately 5 seconds.
The following message will be displayed: "WATER
CHANGE...%". The water from the boiler will drain from the
hot water nozzle (20) ( 0 - 70
The boiler resistance and all dispensing keys will be disabled.

13. Cup Warmer (where applicable)

CAUTION: do not cover the cup warmer tray
with any type of cloth.
The machines have a cup tray (3) for stocking the cups.
Only place cups and glasses used with the coffee machine
on the cup tray. No other objects must be placed on
the tray.
Thoroughly drain the cups before placing them on the tray.
A
version. Note. The heating of the cup-warmer tray
(3) is deactivated during the automatic switch-off phase.
The condition in effect at the time when the machine was
switched off will be restored the next time the machine
automatically switches on.
By activating the ENERGY SAVING, mode the cup-warmer
is automatically set to Level 1.
To activate the resistance of the cup warmer tray (23) press
button (22) to change the cup-warmer power, press the
B
version. Press the button (10) and check to see that
the light turns on.
ca. of the total capacity).
15 EN
20
Dispensing will stop automatically (Note. The delivery can
be interrupted in whichever moment by means of the push
button 11).
After the procedure, the machine will return to its normal
functions and the boiler will be re lled with fresch water.
A
10
(22) key a number of times.
- = maximum power symbol
- = medium power symbol
- = minimum power symbol
- no symbol = OFF
Therefore, to disable tray heating (23), press the key (22)
several times until no symbol is visible on the display.
B
3
11
3
10
ON