Winmate M101RK Series User Manual page 76

76 10.1" Rugged Android Tablet M101RK Series User Guide
No sound is produced.
I cannot project the tablet computer
display to another monitor.
Barcode scanner does not emit laser
beam and does not seem to work.
Barcode Scanner emits laser beam but
does not read barcode presented to it.
Battery leaking or swollen
Problem
Adjust volume of the tablet computer by pressing
•
on the volume rocker.
• If using an external audio device, make sure that
the cable is properly connected.
Make sure the VGA driver is installed.
•
Make sure the output setting selected is correct.
•
• Make sure the Barcode scanner device is detected,
please open WDC application and check Data
Capture "About".
If the device is not detected in WDC application
•
under Data Capture "About", please press
Reset Setting in Data Capture.
• Adjust the distance between barcode scanner of
the device and the barcode being scanned.
Make sure the barcode code type is enabled in the
•
tablet. To enable/disable a specific barcode code
type, go through
Configuration" section.
• The lithium battery used in this tablet may swell
after being charged/ discharged many times, but
there is no problem regarding safety.
Continued use in such a state may result in the
•
battery getting jammed, so please stop using the
battery, and purchase a new one.
Solution
the "Barcode Scanner