Valor L1 Series Installation Manual page 3

5. Once wall fi nishing is complete, place cover plate in
the bottom of the opening. It will rest on the sup-
ports at the bottom corners of the opening. There
are no screws inserted in this step.
Notes:
- The opening in the cover plate should be oriented
as shown below to allow air to enter while obstruct-
ing any view through its opening.
- Each end of the plate has rounded notch opening
to insert the hinge pin of the side doors.
Opening in
cover plate
6. Identify left hand door and its orientation according
to the images below.
Left door
Front view
Cover plate
TOP of door:
this space is
wider
TOP of door:
tab at the rear
BOTTOM of door:
this space is
narrower
Rear view
7. Insert the left hand door top hinge pin in the hole at
the top of the CIK frame, then the bottom hinge in
the hole of the cover panel. Turn the door in toward
the back of the fi replace.
Top pin
8. Repeat for right hand door.
9. Place the magnetic barrier screen into the CIK frame
opening with the tabs at the bottom.
Assembly of the kit is complete.
Bottom pin
3