Checking The Tyre Inflation Pressure - Kia Soul 2018 Owner's Manual

Checking the tyre inflation
pressure
1. After driving approximately 7~10
km (4~6 miles or about 10 min-
utes), stop at a suitable location.
2. Connect connection hose (9) of
the compressor directly to the tyre
valve.
3. Connect between compressor and
the vehicle power outlet using the
cable and connectors.
4. Adjust the tyre inflation pressure
to the recommended tyre inflation
pressure. With the
switched on, proceed as follows.
- To increase the inflation pres-
sure: Switch on the compressor,
position "I". To check the current
inflation pressure setting, briefly
switch off the compressor.
✽ ✽ NOTICE
The pressure gauge may show high-
er than actual reading when the
compressor is running. To get an
accurate tyre pressure, the compres-
sor needs to be turned off.
WARNING
Do not let the compressor run
for more than 10 minutes, other-
wise the device will overheat
and may be damaged.
ignition
What to do in an emergency
- To reduce the inflation pres-
sure: Loosen the screw cap (8)
on the compressor hose.
CAUTION
If the inflation pressure is not
maintained, drive the vehicle a
second time, refer
Distributing the sealant. Then
repeat steps 1 to 4.
Use of the TMK may be ineffec-
tual for tyre damage larger than
approximately 4 mm (0.16 in).
Contact a professional work-
shop if the tyre cannot be made
roadworthy with the
Mobility Kit. Kia recommends to
visit an authorised
dealer/service partner.
WARNING
The tyre inflation pressure must
be at least 200 kPa (29 psi). If it
is not, do not continue driving.
Call for road side service or
towing.
to
Tyre
Kia
7 29