Distributing The Sealant - Kia Soul 2018 Owner's Manual

What to do in an emergency
9. With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
and Wheels, chapter 8). The infla-
tion pressure of the tyre after filling
is unimportant and
checked/corrected later.
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
When the tyre and wheel are dam-
aged, do not use Tyre Mobility Kit for
your safety.
CAUTION
- Tyre pressure
Do not attempt to drive your
vehicle if the tyre pressure is
below 200 kpa (29 PSI). This
could result in an accident due
to sudden tyre failure.
7 28
10. Switch off the compressor.
11. Detach the hoses from the
sealant bottle connector and
from the tyre valve.
Return the TMK to its storage loca-
tion in the vehicle.
will be
WARNING
Carbon monoxide poisoning
and suffocation is possible if
the engine is left running in a
poorly ventilated or unventilat-
ed location (such as inside a
building).

Distributing the sealant

12. Immediately drive approximately
7~10km (4~6miles or, about
10min) to evenly distribute the
sealant in the tyre.
CAUTION
- Carbon
Do not exceed a speed of 60
monoxide
km/h (35 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
Whilst driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road. Call for
road side service or towing.
When you use the Tyre Mobility
Kit, the tyre pressure sensors
and wheel may be stained by
sealant. Therefore, remove the
tyre pressure sensors and have
the vehicle inspected at a pro-
fessional workshop. Kia recom-
mends to visit an authorised Kia
dealer/service partner.