LawnMaster GT1313 Operator's Manual page 11

ASSEMBLY
■ Position steel flower guard and snap into the debris guard as shown. The flower guard must be placed
under the plastic tabs (Fig. 2 & 3).
■ With flower guard extended, place entire debris guard with flower guard over the spool head and align it.
■ Once aligned, rotate debris/ flower guard assembly so the two screw holes align as shown (Fig. 4 & 5).
■ Use remaining screw to fasten the assembly to the motor housing.
FITTING THE ASSIST HANDLE (See Figs. 6-7)
■ Place the assist handle on the grass trimmer as shown (Fig. 6).
■ Adjust the assist handle to the most comfortable position. Use the marking as a guide.
■ Pass the bolt through the assist handle and the upper handle (Fig. 7).
■ Screw the nut into the other side of the bolt. Do not over tighten the bolt.
Fig. 2
Fig. 4
Fig. 6
11
Plastic Tabs
Fig. 3
Align
Holes
Fig. 5
Fig. 7