Remote Control Specification; Storage Instructions - Kennedy II 42 / JR-42S Manual

Remote Control Specification

1.Model: R302
2. Remote Key: 12
3. Communication: Infrared
4.Infrared Distance: 6 Meters
5. Battery: AA x 2pcs
NOTE: Make sure your "AA" batteries (x2) are
fully charged and installed correctly in your
remote control before operating.
The remote control must remain within 6
meters of the appliance to be effective, this
range may be reduced when battery power is
depleted.
Maintenence
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
DO NOT INSTALL LED LIGHT STRIPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE LED LIGHT STRIPS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE STRIPS TO AVOID
DO NOT HANDLE THE LED LIGHT STRIPS WITH BARE FINGERS. USE GLOVES OR A CLEAN DRY

Storage Instructions

Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the
injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other applicable
Do not attempt to wire your own new outlets or circuits. T
persons, always use a licensed electrician.
Page 18
PREPARATION FOR MAINTENANCE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
ACCIDENTAL BURNS.
CLOTH WHEN HANDLING.
WARNING
08.19.20