Dimensions PRODUCT DIMENSIONS CARTON DIMENSIONS Model No. F/F’ Width x Depth x Height JR-42S / EF-WM502 42” 11.8” 1.3” 16” 44.4” 62.99" W X 9.45” D X 24.80" H 18.3” 4.6” 47.0” / EF-WM502 GY 119.4cm 106.7cm 30cm 3.3cm 40.6cm 112.8cm 160cm W X 24cm D X 63cm H 46.5cm 46.5cm...
Page 9
Option 1: Hanging the Appliance on the Wall NOTE: It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to the wall and the bracket is adequately secured 07.23.2023...
Page 10
Option 2: Recessing the Appliance Flush into the Wall NOTE: The slim design of our units allow 07.23.2023...
Page 14
Front Glass Removal Crystal Embers and Wood Logs Installation 07.23.2023...
Page 15
Ensure steps 1-2 in the"Main Power Switch"procedure are first followed. 2. Press the “ button to turn on/off the fireplace; If turn on (indicate "ON"), the Red, blue and yellow flame (F4), ember bed (E3) LEDs at the brightest level. Press again, the heater is in OFF status indicate "OF", goes off after 5 seconds.
Page 16
3. Reset the Fireplace by pressing and holding the flame button for 5 seconds, then release. 4. A connecting progress screen will show network scanning is active until the device is added succcesfully. The Kennedy Fireplace control screen will now be active. 4. Check for Firmware Update 5.
Voice Control • Available for Alexa and Google Assistant, you can use voice commands to control many features of the fireplace. Install the Alexa app and Google Assistant first and follow the steps below to use voice control. • IT IS IMPORTANT TO USE THE EXACT PHRASES AS VARIATIONS MAY NOT WORK. •...
Page 18
Multi-functional Operating with Remote Control Turning ON/OFF the appliance: Ensure steps 1-2 in the"Main Power Switch"procedure are first followed. Changing LED options: . ( , Note: Steps 2- can be done independently. Page 18 07.15.23...
Replacement Parts WARNING FAILURE TO POSITION THE PARTS IN ACCORDANCE WITH THIS MANUAL OR FAILURE TO USE ONLY PARTS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. To order parts, contact customercare@jrhome.com FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OF THE ORIGINAL INVOICE WILL BE REQUIRED TO HONOUR THE CLAIM.
Page 23
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE. Symptom Potential Cause Solution Abnormal noise From heater assembly (item 7) Blower assembly has a defect that is causing noise during high speed rotation.
Troubleshooting Symptom Potential Cause Solution wire loosing necessary light is not glowing or dimming or wire loosing necessary out or wire loosing necessary Main circuit board burnt out or Inspect the Main circuit board and re- wire loosing place if necessary No warm air coming Room temperature is higher Reset temperature setting...
Page 25
2 Years 2 Annees IMPORTANT For questions, concerns or problems with our product please Si vous éprouvez des dicultés, ou si vous avez des questions ou des email our customer service department: préoccupations, prière de faire parvenir un courriel à notre Service à la clientèle customercare@jrhome.com customercare@jrhome.com DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE...