Kennedy II 42 / JR-42S Manual page 9

Option 1: Hanging the Appliance on the Wall
Due to the many different materials used on different walls, it is highly recommended that you consult your
local builder before you install this appliance on the wall.
1. Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
2.
3. Remove the bracket from the back of the unit by removing the two screws, refer to Figure 4.
4. Mark out location, then mount the bracket onto the wall using the 8 supplied screws. This bracket MUST
have the hooks facing upward and be level.
NOTE: It is strongly recommended that the mounting bracket be screwed into the wall studs
where possible. If the wall studs cannot be used, ensure that the supplied plastic anchors are
used to affix the bracket to the wall and the bracket is adequately secured
5. With the wall mounting bracket installed have two people lift the appliance up and insert the two hooks
on the bracket into the two slots on the back of the appliance.
6. Check the appliance for stability ensuring that the bracket will not pull free from the wall.
FIGURE 4
08.19.20
BRACKET
Bracket for JR42S/EF-WM502
Bracket for JR50S/EF-WM503 and JR60S/EF-WM504
Bracket for JR-72S/EF-WM505
Page 9