Table of Contents
Advertisement
System LED
Flashing White
White
Blue
Steady Blue with
Occasional Flashing
Quickly Flashing Blue
Alternating Blue/White
RJ45 Speed/Link/Activity LED (Ports 1 - 8)
Off
Amber
Green
SFP Link/Activity LED (Ports 9 - 10)
Off
Green
RJ45 (Ports 1 - 8)
RJ45 ports support 10/100/1000 Ethernet connections.
PoE In (Port 1) Supports 24V Passive PoE input.
PoE Out (Port 8) Supports 24V Passive PoE passthrough.
SFP (Ports 9 - 10)
Hot-swappable SFP ports support 1 Gbps connections. If you use a copper Ethernet
module (example: UF-RJ45-1G), power off the EdgeSwitch before insertion;
otherwise there may be a device reboot.
Reset Button
To reset to factory defaults:
1. Disconnect power from the EdgeSwitch.
2. Reconnect power while holding the Reset button. The port LEDs will light up in
sequential order (this takes approximately five seconds).
3. When the port 1 LED flashes again, release the Reset button.
Power
Connect the included Power Adapter to the Power port.
Grounding Point
Ground bonding point for an optional ground wire.
Bootup in Progress
Ready for Use
Not Connected to Ubiquiti® Network Management
System (UNMS™)
Ready for Use
Connected to UNMS
Ready for Use
Unable to Connect to UNMS
Used to Locate a Device in UNMS
Firmware Upgrade in Progress
No Link
Link Established at 10/100 Mbps
Flashing Indicates Activity
Link Established at 1000 Mbps
Flashing Indicates Activity
No Link
Link Established at 1 Gbps
Flashing Indicates Activity
Advertisement
Table of Contents
