Motorola MBP36XL Faq

Hide thumbs Also See for MBP36XL:

Download this manual

General FAQ

What do I do if I lose the link between my Baby and Parent units?

Related Products Motorola MBP36XL

• Try recharging or press the RESET button once on the Parent Unit.

• If the Baby Unit is too far away it may be going out of range, so move the Baby Unit closer to

the Parent Unit.

• Reset the units by disconnecting the Baby Unit from electrical power and press the RESET

button once on the Parent Unit. Wait about 15 seconds before reconnecting. Allow up to one

minute for the Baby Unit and the Parent Unit to synchronize.

• If there is a need to re-register the units see section 2.3 in the main user guide.

My temperature display has °C. What does this mean?

Related Products Motorola MBP36XL

This monitor has the option of displaying Fahrenheit or Celsius scales for temperature. You may

choose to display either from the temperature menu.

Why is my display blank?

Related Products Motorola MBP36XL

• Try recharging or press the RESET button once.

• Reset the units. Press the RESET button once on the Parent Unit and unplug both the units'

electrical power, then plug them back in.

• Is the unit turned on (green ON/OFF LED lit)? Press and hold the ON/OFF button on the Parent

Unit to turn it ON.

• Is the correct camera selected? Change the camera number, if necessary.

• Is the video display turned on? Press the VIDEO ON/OFF button to turn it on.

• When operating using batteries only, the Display will go blank after 5 minutes or 30 minutes

or 60 minutes to save power (depending on video settings). The unit is still active and will give

you audio alerts. You can reactivate the screen by pressing any button.

Why am I getting a loud high pitched noise?

Related Products Motorola MBP36XL

• Your Baby and Parent Units may be too close to one another. Move them farther apart.

• Make sure there is at least 1 to 2 metres between the 2 units to avoid audio feedback.

Why am I hearing interference on my Parent unit?

Page 1 General FAQ What do I do if I lose the link between my Baby and Parent units? Related Products Motorola MBP36XL • Try recharging or press the RESET button once on the Parent Unit. • If the Baby Unit is too far away it may be going out of range, so move the Baby Unit closer to the Parent Unit.
Page 2 Related Products Motorola MBP36XL • lf the baby unit is too far away it may be out of range, so move the Baby Unit closer to the Parent Unit. • Make sure the Baby and Parent Units are not near other electrical equipment, such as a television, computer or cordless/mobile telephone.
Page 3 I have more than one camera paired but the view is from only one camera. How do I select which camera I am viewing? Related Products Motorola MBP36XL This function is only available when you have more than 1 Baby Unit (Camera). 1. Press the MENU button and the menu bar will pop up.
Page 4 Related Products Motorola MBP36XL The Stargrip screws to the bottom of several cameras and will connect to the Orbit but we don't promote it. It is used to elevate and angle the camera if placed on a dresser or other flat surface.
Page 5 • Is the correct camera selected? Change the camera number, if necessary. • Is the video display turned on? Press the VIDEO ON/OFF button to turn it on. • When operating using batteries only, the Display will go blank after 5 minutes or 30 minutes or 60 minutes to save power (depending on video settings).