Parameter Setup - Gemini 514 User Manual


Before configuring the parking sensors, ensure all connections have been done properly.

Parameters must only be configured by qualified personnel.
System configuration is done by pressing buttons "A" and "B" (see figure below) or via a user-friendly PC software:

Press button "A" to select the parameter to configure.

Press button "B" to select the desired setting.
How to enter in programming mode:
1. Turn ignition ON and engage reverse gear.
2. Simultaneously press buttons "A" and "B" to enter in programming mode.
3. Operation will be confirmed by 1 Beep and 1 Red/Green LED flash.
4. Wait until the LED turns OFF.

Parameter setup:

1. Within 10 sec. after the LED turns OFF, press button "A" the number of times corresponding to the number of the parameter to customize. After
each button press there will be 1 Beep and 1 Red LED blink.
2. Press button "B" the number of times corresponding to the desired setup. After each button press there will be 1 Beep and 1 Green LED blink.
Example: To set the maximum detection distance of the inner sensors at 125 cm => press button "A" twice and then button "B" 7 times.
Setup confirmation:
1. The control unit will repeat the number of beeps and blinks corresponding to the selected setup. After a few seconds, if the code has been
successfully entered, the buzzer will give off a long beep (Beep, Beep, Beep) and the system will automatically exit the procedure.
2. If the entry is incorrect, the buzzer will emit a low tone signal (Bop) and automatically exit the procedure.
3. After the confirmation Beeps, other parameters can be configured by following the same procedure.
If no button is pressed within approx.10 sec., the system automatically exits programming mode
4.
Restore factory settings
a) Procedure A
1. Before engaging reverse gear, simultaneously press and hold buttons "A" and "B"; turn ignition ON and engage reverse gear.
2. The LED will start blinking Red/Green.
3. When the buzzer gives off a Beep, release buttons "A" and "B".
When the LED stops blinking, the system is reset to the original factory settings
4.
b) Procedure B
1. Disconnect the connector from the unit.
2. Turn ignition key ON and engage reverse gear.
3. Simultaneously press and hold buttons "A" and "B" and reconnect the connector.
4. The LED will start blinking Red/Green.
5. When the buzzer gives off a Beep, release buttons "A" and "B".
6. When the LED stops blinking, the system is reset to the original factory settings.
PARAMETER SET-UP
.
7/10
LED
Button B
Button A
.
Rev.01 09/2015