Gemini 514 User Manual page 6

PARKING SYSTEM AUDIBLE SIGNALS
When reverse gear is engaged, the parking sensor system provides an instant, automatic, self-diagnostic function. If all the sensors are operative, 2 Beeps will
confirm activation.
In case one of the sensors is faulty or disconnected, a deep error tone (Bop) will sound followed by the number of beeps corresponding to the faulty sensor. The
cycle will repeat until all faulty sensors have been signaled. 2 Bops will confirm the end of the self-test cycle.
The system will exclude any faulty sensor and keep the others active. The following is an example of error indications:
Sensor 1 inoperative => 2 activation Beeps + 1 Bop + 1 Beep + 2 closing Bops.
Sensors 1 and 2 inoperative => 2 activation Beeps + 1 Bop + 1 Beep + 1 Bop + 2 Beeps + 2 closing Bops.
CHECK AFTER INSTALLATION
1. Connect the negative cable to the battery and check operation of all lights and other electrical accessories.
2. Turn ignition key ON and engage reverse gear. Activation will be confirmed by 2 Beeps.
3. Test the sensors one by one for detection by moving different obstacle simulators behind the vehicle. The system should beep according to the warning
zones.
NB: If necessary, modify the sensitivity setting (see parameter setup table).
4. If the parking sensors are working correctly, secure the bumper in place.
6/10 Rev.01 09/2015