Regen Ddl-S - Art SGX-2000 User Manual

:REGENeration = 0 to 100 percent in % increments [76%]
:LEVEL= 0 to 100 percent in % increments [100%]
*Total delay possible is 1010ms.
TAP'D-DDL-L
[TAP'D-DDL-L], [DDL]
Tapped Digital Delay - Long
Parameters:
:TYPE:= FLAT-1m, FLAT-1s, RVRS-1m, RVRS-1s, SLOPE1m, SLOPE1s, (E)
FLAT-2m, FLAT-2s, RVRS-2m, RVRS-2s, SLOPE2m, SLOPE2s, (S)
FLAT-3m, FLAT-3s, RVRS-3m, RVRS-3s, SLOPE3m, SLOPE3s
:TAPS= 1 to 7 in one step increments [3]
:DELAY* = 0 to 1100ms [240ms]
increments:5ms;0-350, 10ms;350-700
20ms;700-1000, 50ms;1000-1100
D-FINE* = 0 to 50ms in 1ms increments [0ms]
:REGENeration = 0 to 100 percent in % increments [76%]
:LEVEL= 0 to 100 percent in % increments [100%]
*Total delay possible is 1150ms
There are three levels of tapped delays in the SGX 2000. These are what we call
Even (E), Shortened (S), and Lengthened (L). (1's are Even, 2's are Shortened,
3's are Lengthened) Even means that the delay taps are at evenly spaced
intervals. Shortened means that as the taps approach the set delay, the intervals
are closer together. As the taps approach the set delay in the Lengthened mode
they are farther apart. In the types you will see an [m] and an [s], the [m]
means mono and the [s] signifies stereo. The mono tapped delay has its left and
right taps at the same delay points where the stereo taps are staggered. When
using the stereo tapped delays the first right tap is half the delay time before
the first left tap.
There also are three slopes used in the tapped delays, Flat, Reverse and Forward.
Flat has a flat linear response. Reverse increases in amplitude exponentially
the signal approaches the end. Forward exponentially decreases in amplitude as
the signal approaches its end point.
TYPE 3 taps are dense and full. Use the longer tapped delay programs to add some
expansiveness to short reverb patches. Use the longer tapped delays especially
the Sloped algorithms to create a fundamental front end reverb.
REGEN-DDL-S
[REGEN-DDL-S], [DDL]
Regenerated Digital Delay - Short
Parameters:
:DELAY* = 0 to 960ms [100ms]
increments:5ms;0-350, 10ms;350-700
20ms;700-960
D-FINE* = 0 to 50ms in 1ms increments [0ms]
:REGENeration = 0 to 100 percent in % increments [76%]
:LEVEL= 0 to 100 percent in % increments [100%]
*Total delay possible is 1010ms.
(L) [FLAT-1m]
as
31